Our production process of brake pads is described as follows:
First, the raw materials required for brake pad manufacturing shall be mixed according to a certain ratio, broken and mixed evenly, and the mixing time and the order of adding different raw materials shall be strictly controlled;
Second, steel back preparation, including sanding, preheating and glue spraying;
Third, curing treatment should be carried out to stabilize the performance of brake pads;
Fourth, the appearance and surface of the brake pad shall be treated. According to the requirements of the customer, the car brake pad shall be grooved, ground, chamfered and drilled, and the thermal stability of the brake pad shall be maintained. The rust can also be removed by painting and high-voltage electrostatic spraying to ensure the beauty of the car brake pad;
Fifthly, we should spray the trademark code to make the products carry the company's proprietary logo;
Finally, riveting is carried out to tighten the brake pad, so that the brake pad will not shake during use.
